![]() ![]() The CC-Link V2 network supports up to 1008 bits and 128 words of input and output data while also capable of occupying between one and four stations and using between one and eight cycles. The CC-Link V1 network supports up to 112 bits and 16 words of input and output data while also capable of occupying one station and using between one and eight cycles. This connection only supports data synchronization, and does not provide a built-in means to send commands (such as "trigger," "change job," or "Online/Offline") from the Automation Controller to the vision system. CC-LinkĬommunication between an Automation Controller and an In-Sight vision system on a CC-Link network is facilitated through the use of the In-Sight CIO-MICRO-CC I/O module. In-Sight vision systems can also be configured for the iQ Sensor Solution using the SLMP Scanner protocol. The In-Sight 2000 series vision sensor does not support robot controllers. *CC-Link is only available on In-Sight vision systems using In-Sight firmware 4.x.x, and is not available on In-Sight vision systems/sensors running In-Sight firmware 5.x.x or later. In-Sight vision systems support three methods for communicating with Mitsubishi MELSEC Automation Controllers: Also, in this topic, Robot PLC/MC and Controllers are referred as "Automation Controller". Note: The term Programmable Logic Controllers/Motion Controllers (PLC/MC) is used in the In-Sight Explorer GUI, which is synonymous with the term Automation Controllers. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |